Manufacturers Automation              1-800-387-6268

• Assigning an IP address to the MaxStream 9XTend ethernet wireless modem involves configuring a computer to act as a network. This is accomplished by modifying the local area connection of the computer.
• If the computer (laptop) does not have a serial communication port, make sure to install a usb to serial adapter. The MaxStream X-CTU redirector software must be able to detect a serial communication port on the computer.
• Connect a cross-over ethernet cable from the computer’s ethernet port to the MaxStream 9XTend’s ethernet port.

Windows XP Setup

• Change the properties of the Local Area Connection.
• Go to Start, Settings, and then Network Connections.
• Select Local Area Connection and then Properties.
• Scroll down the list and select Internet Protocol (TCP/IP).
• Select Use the following IP address and enter 10.1.110.10 The last digit prevents a network conflict
• Note: The MaxStream ethernet 9XTend factory default IP address is 10.1.110.11

MaxStream 9XTend Ethernet Wireless Modem Setup

• Install the X-CTU and then the Redirector software.
• Reboot the computer if prompted to do so.
• Open the X-CTU software.
• Enter the new IP address and make sure the virtual com port is com 5 or above.
• Under Changes, click the Apply tab to refresh the settings.
• Exit the X-CTU program and reboot the computer.

Security Feature

• All MaxStream wireless devices have a VID (Vendor ID) and require a four digit hexadecimal number.
• Choose a four digit number and use the weblink below to convert it to hexadecimal.
• http://www.manuauto.com/decimal-to-hexadecimal-converter/
• Input the four digit hexadecimal code and click the Write tab to update the configuration .

MaxStream 9XTend Ethernet and Serial Modems

• Communication between two MaxStream 9XTend Ethernet wireless modems will not work as a bridge. Since the Ethernet (TCP/IP) protocol is removed by the Ethernet-to-serial converter inside the unit, the radios can only transmit and receive serial data over the air. A receiving radio in this case, would only see the serial data and all network information would be lost. This means the network would not be able to see the remote radio.
• The receiving radio must be a MaxStream 9XTend serial wireless modem.
• Set the MaxStream 9XTend serial wireless modem dip switches 1 & 5 in the on position.

Troubleshooting

• Disable the wireless on the PC.
• Turn off the firewall.
• Reboot the computer.

At Manufacturers Automation Inc., we are dedicated to customer service and want to make your experience with Adaptive led displays and the MaxStream RF Modems a pleasant one.

© Copyright 2009, Manufacturers Automation Inc., www.manuauto.com